Main features of three-process engraving machine:
1. This equipment is mainly used for engraving complex patterns on cabinet doors, high-end furniture, and set doors (one plate requires multiple tool changes)
2. We position the configuration of this equipment at the mid-to-high end. The price of the equipment can satisfy most customers, and the functions of the equipment can also satisfy most customers.
3. This equipment uses a 30mm long slider with flange and a genuine Weihong control card. This is the configuration of some parts of the equipment. I believe that customers who know the engraving machine will know the specific performance of this equipment. The engraving machine is used to assemble a computer. In the same way, what kind of things are used and what can be done are already determined.
4. The main shaft motor of the equipment is a 4.5KW water-cooled motor and two 3KW auxiliary shaft motors.
5. The vacuum pump uses a 5.5KW water circulation vacuum pump. If the temperature in the customer’s location is particularly low in winter, it is recommended to use a waterless vacuum pump.
6. This equipment is a three-head switching engraving machine. There are three different shapes on one door panel. The program can be set at one time. It is a one-time engraving machine. The three-head switching does not require manual operation. The machine can complete it at one time. The performance of the equipment is particularly outstanding when engraving machine composite patterns.
How to maintain the engraving machine?
The first is the working environment
1. Ensure the operating room ambient temperature, paying special attention to the operating room temperature in winter. The woodworking engraving machine needs to reach room temperature, at least the staff will not feel very cold.
2. Check the applicable temperature of the oil standard, at least reach the lower temperature.
3. When the machine is not in use, if the room temperature is low, the water in the water tank needs to be poured out to prevent the water tank and water pipes from freezing and cracking. Temperature does not have a great impact on the engraving machine, but many customers add butter to the screw and forget to clean it in winter, resulting in the machine not running every time it is turned on. The temperature in some studios is very low, and even though oil has been added, it is still freezing. On, the machine won’t run.
4. The humidity in the operating room cannot be too high, otherwise the electrical accessories of the machine will be easily worn out.
5. You must pay attention to electromagnetic interference in the operation room. If the interference is too large, it will easily affect the processing accuracy of the engraving machine.
Next is sanitation
After using the engraving machine, be sure to clean the dust, wood chips, etc. on the table and exposed electrical accessories, including the machine’s guide rails and sliders, including the machine’s screw and spindle motor. Including the industrial control box of the machine, especially if there is a little too much dust in the industrial control box, it will cause problems with the operation of the circuit board, and it is easy to have breakpoints, random runs, etc.
The third is computer maintenance
Most engraving machines are operated by computers. Once there is a problem with the computer, the entire engraving machine will be unusable, so it is also very important to maintain the computer well. Pay attention to the following aspects when maintaining your computer.
1. Clean the dust on the chassis regularly. Use an air spray gun and a small brush to clean it regularly. Be careful that excessive dust may cause the industrial control to jam. Pay attention to the heat dissipation device of the chassis, especially in summer. Be careful that the temperature of the control line is too high and may burn circuit boards and other equipment.
2. Regularly clean up computer garbage, defragment disks, optimize the computer system, and maintain the stability of the computer system.
3. Check and kill computer viruses regularly, but be careful not to turn on the anti-virus level when working and be careful of interference.
Jinan Dimai CNC Equipment Co., Ltd. mainly produces CNC optimized cutting machines, cabinet door panel processing centers, full wardrobe customization production lines, sliding door soft package processing centers, wooden door processing centers, sofa frame processing centers and many other products. It is a research and development, An enterprise integrating production and sales.